Potatoqueen247
Potatoqueen247 Potatoqueen247
  • 22-04-2021
  • Engineering
contestada

Three (3) Types of Section Views used in engineering drawing are

Plan, Front and End

Orthographic, Isometric and Oblique Section

Full, Half and Offset Section

None of the above

Respuesta :

lamiaanasser51
lamiaanasser51 lamiaanasser51
  • 22-04-2021

Answer:

none of the above

Explanation:

plen ,side and elevation are the three section views

Answer Link

Otras preguntas

Building blocks of protiens are
Why does the narrator take down her guardian angel picture “gravity”
In the United States, the Federal Reserve Board of Governors controls __________. A. fiscal policy B. monetary policy C. federal policy D. reserve policy
Match each consumer protections agency with its objective
What’s that was the US president Bill Clinton take to secure Bosnia and keep the peace there
which concept is stressed by symbolic interactionists?
Factories these 2 plz!!
What happens to the incoming solar radiation after it is reflected off the surface of the earth? The solar radiation bounces off without affecting the earth.
Make these Italian nouns plural: fuoco ago buco albergo sacco sugo
Which of the following was a primary motivation for Japan to seek new territories throughout Asia? A. Japan wanted to draw the United States’ attention away f